Setup

• p5: https://editor.p5js.org/zqyoiv/sketches/3T7DxcruE

Trouble shooting:

• Arduino:
  • close p5, open serial monitor and type command
• Leap Motion:
  • visualizer debugger
• physical connection:
  • check light and arduino power source

Next Steps

• acrylic cube/tube put at bottom of Leap Motion
• laser cut bigger holes for screws to allow tolerance
• figure out how to hang on the wall

Instructions

Instructions:
To turn each light on, point at or hover your hand over it. 
To turn all the lights on, make a fist.